![]() Then, select the buttons on the right keyboard in turn. You have to memorize the exact position and order of the lighted boxes. And on the left screen, the blue blocks light up one after another. In reactor, a screen with keyboard will appear. Once you’ve “cleaned” the air, the task is complete. In O2, drag leaves from the air and push them into a chute on the left to dispose of. This takes about 10 seconds and afterwards the task will be complete. A green scanner will start scanning the player’s body and all information will be displayed on the screen. In Medbay, you must step up to stand in the middle of a circular platform. To complete this task, you must correctly wire three panels. When all four wires have been connected, that panel is done. You must connect each end of the wire of the same color on the two sides together. This task is randomly appears over the map. You must move the cross with the mouse and click to fire and destroy 20 meteors. ![]() This task, located in Weapons, when opened will display a green screen showing meteors in flight. Then, go to the next location (Communications, Lower Engine, Navigation, O2, Shields, Security, Upper Engine, or Weapons) and click on the fuse shape icon to allow the current to flow. To do this, drag the adjustment knob on the corresponding panel slider upwards. First, you must accept power in electrical. This task consists of 2 phases: divert the power and accept the power. Once you’ve emptied garbage at both locations, you have completed the mission. And hold it until the trash has been completely emptied. To empty the trash, hold down the lever on the right hand side of the bin from top to bottom. Empty Garbageįor this task, you must empty trash from two different locations (Cafeteria and Storage). Head to navigation and drag the circle into the center of the panel so that its lines overlap the center cross. You must do the process twice for both engines. Afterwards head to the engines and refuel them. Fuel Enginesįor this task, you must take fuel at Storage. If a blue test tube is selected, the task fails and must be redone. You need to press the green button below the red test tube to complete the task. When the machine is finished processing the patterns, there will be four blue tubes and one red tube. This process takes about 1 minute and you can leave the area and do other tasks. Inspect SampleĪt Medbay, press a button so that the machine begins to process five different test tubes. You align both engines in the engine rooms to complete this task. After holding for a few seconds, the motor will align. You must adjust and keep the direction of the engine by dragging and dropping the arrow so that the blue line matches the red horizontal line in the middle. If you fail to match one, you’ll have to start from the first calibration. Once you calibrate correctly and 3 lights are lit, you have completed the task. Each “level” has its own color and speed. To complete this task, located in electrical, you need to press the button to pair the rotating power supply at the right time. ![]() Then the data must be uploaded in the Admin room, taking another 8.5 seconds. You will reach the first location and wait for the data download (8.5 seconds) to finish. This task requires you to download (either in Cafeteria, Communications, Electrical, Navigation, or Weapons) and re-upload (in Admin) data. ![]() To finish the task, you must drag the ship through a series of four points. If you swipe too fast or too slow, you will have to redo the task. However, you must be careful to swipe the card at the right speed. ![]() You must take your card from your wallet and swipe across the device from left to right. Swiping your card is a short task located in the admin room, on the right side of the central panel. How to Complete Every Task on The Skeld map Swipe Card How to Complete Every Task on The Skeld map. ![]()
0 Comments
Leave a Reply. |